Sample Easytrieve apply JCL for maintenance

Products

• Easytrieve Report Generator

Issue/Introduction

The maintenance for Easytrieve in the past has been installed via CSM. Where is the JCL found to APPLY the maintenance via a batch job?

Environment

Easytrieve Report generator, Release : 11.6

 

Resolution

This is the JCL, member EZT7APYP, located within the SAMPJCL library:

//jobcard
//********************************************************************
//*                                                                  *
//* YOU MAY USE THIS JCL TO APPLY DOWNLOADED FIXES.                  *
//*                                                                  *
//* THIS APPLY PROCESSING WILL ALSO SELECT                           *
//* SERVICE FOR OTHER FUNCTIONS WHICH ARE INSTALLED IN THIS          *
//* TARGET ZONE, IF THE SERVICE IS NEEDED TO SATISFY AN IFREQ.       *
//*                                                                  *
//* SEE THE APPLY COMMAND CHAPTER IN THE SMP/E COMMANDS MANUAL FOR   *
//* THE SELECTION HIERARCHY FOR THE APPLY COMMAND.                   *
//*                                                                  *
//* THE COMMAND SHOWN BELOW BYPASSES SYSTEM HOLD REASONS ACTION,     *
//* AO, DEP, AND DOC.  REFER TO THE DOC HOLDS FOR DOCUMENTATION      *
//* CHANGES.  YOU WILL NEED TO RESEARCH ALL PTFS WITH SYSTEM HOLDS   *
//* FOR REASONS OTHER THAN "DOC".  RUN THIS JOB WHEN YOU HAVE        *
//* DETERMINED THAT YOU CAN COMPLY WITH THE CONDITIONS SPECIFIED     *
//* IN THE SYSTEM HOLDS.                                             *
//*                                                                  *
//********************************************************************
//* Copyright (C) 2011 CA.   All Rights Reserved.                    *
//********************************************************************
//*                                                                  *
//APPLY    EXEC PGM=GIMSMP,PARM='DATE=U',REGION=0M
//SMPCSI   DD DISP=SHR,DSN=your.highlevel.qualifier.CSI
//SMPCNTL  DD   *
SET BOUNDARY (CAITGT) .
APPLY PTFS  GROUPEXTEND(NOAPARS NOUSERMODS)
  FORFMID (
      CBAAB60 /*CA Easytrieve Runtime */
      CCL2B60 /*CA Easytrieve/Plus Compatibility Library */
      CA03B60 /*CA Easytrieve Compiler */
          )
  BYPASS(HOLDSYS(ACTION AO DEP DOC) HOLDCLASS(ERREL)) .