I'm trying to perform a transfer with XCOM version:
CA XCOM Data Transport r11.6 21110 SP01 64bit (for <no SNA support>)
using the following command:
# xcomtcp -c1 -f /XCOM/config/xcomtst.cnf LOCAL_FILE=/temp/Test REMOTE_FILE=/Test/Rmtfile XENDCMD=/XCOM//xcomend.sh
The following error is received:
ERROR: The XENDCMD field is a global parm that cannot be overridden
The same transfer with the following version ran successfully:
CA XCOM Data Transport r11.6 15031 SP00 64bit (for <no SNA support>)
Release : 11.6
Component : XCOM DATA TRANSPORT for Windows
Parameter XENDCMD is only valid in the xcom.glb file and cannot be specified as a parameter on the "xcomtcp" command. The fact that it was possible to do so with r11.6 SP00 has been corrected with fix LU02560.
1. The same would be with any of the other pre/post processing scripts parameters:
XPPCMD=, XPRECMD=, XLPCMD=, XNOTIFYCMD=
2. Here is the list of XCOM platforms and the fixes that corrected the problem:
Windows r11.6 SP02 & SP03 - LU02560 (Version: 11.6.2110.0)
Windows r11.6 SP00 & SP01 - LU04748 (Version: 11.6.2202.0)
Linux r11.6 SP01 - LU02711 (Version: 11.6.2109.2)
Linux r11.6 SP00 - LU04708 (Version: 11.6.2202.0)
IBM AIX r11.6 SP01- LU03368 (Version: 11.6.2111.0)
IBM AIX r11.6 SP00 - LU04729 (Version: 11.6.2202.0)
Solaris Sparc r11.6 SP01- LU03648 (Version: 11.6.2111.2)
Solaris Sparc r11.6 SP00 - LU04731 (Version: 11.6.2202.0)
Solaris x86 r11.6 SP01- LU03449 (Version: 11.6.2111.1)
Solaris x86 r11.6 SP00 - LU04730 (Version: 11.6.2202.0)
Linux for zSeries r11.6 SP00- LU03723 (Version: 11.6.2111.3)
HP-UX IA64 r11.6 SP00- LU04451 (Version: 11.6.2201.1)