ADMIN BY information does not show up

Products

• Top Secret

Issue/Introduction

Before the apply of LU00345 the ADMIN BY information appeared when a user was listed.

For example :

DIGICERT = CERTname         ACCESSORID = ABCD                          
   ADMIN BY= BY(ACIDxxx)    SMFID(smfid)   ON(12/11/2020)  AT(10:12:40)

 

After the apply of LU00345 the ADMIN BY information does not appear in the list.

Environment

Release : 16.0

Component : Top Secret for z/OS

Cause

The description of the problem solved by LU00345 is as follows:

 

PROBLEM DESCRIPTION:

With ADMINBY(NO) and/or TERSE command options specified for CA Top Secret,
LIST command output can still display the ADMINBY information for various
resources.

The command option settings that should prevent ADMINBY information from
being displayed on LIST command output are:
 

ADMINBY(NO)
TSSCMDOPTION(ADMINBY,TERSE)
TSSCMDOPTION(NOADMBY)


SYMPTOMS:
The ADMIN BY line is displayed for various resources on output of the
LIST command.
 

IMPACT:
Additional lines are displayed for ADMIN BY information that were not
requested.

Before the apply of LU00345 the LIST command listed ADMINBY info that should not appear if the ADMINBY control option is NO or the TSSCMDOPTION contains TERSE.

Now, With the LU00345 applied, if ADMINBY control option is NO or the TSSCMDOPTION contains TERSE, the LIST command will not display the ADMINBY.

 

 

Resolution

Change the ADMINBY control option to YES

 

Additional Information

Information about the ADMINBY control option is available at the following link:

ADMINBY—Record Administration Information