Mount authority in Job Mode

Products

• View

Issue/Introduction

Hello, in our environment, we set init parameter of MOUNT to YES and then granted Mount authority/attributes.

 

Since then, mounting in MODE ALL is available, but it does not work in MODE JOB, if I try to select report that resides on TAPE I get:

If I open report by line command ? and then select particular DD name, I get following message:

Is it standard behavior, or did we set something incorrectly?

 

On other environments we use SAREAS - that works correctly. I am wondering if we can set CA View to perform manual mounts automatically from TSO without SAREAS.

 

Environment

Release : 14.0

Component : View

Resolution

By design, in Job Mode,users cannot access reports that are only on tape without first reloading the report to disk or starting SAREAS