dr_validate.sh failed

Products

• CA Performance Management - Usage and Administration
• DX NetOps

Issue/Introduction

We are upgrading the ca pm and CA DR server is showing error , while running the dr validation script.

Environment

DX NetOps Performance Management

Cause

None, script was optimizing the system for vertica installation.  The following was seen in the validate log

"This script made changes that require a reboot of the system before we can proceed with the Vertica installation.  Please run this script after the reboot to ensure all pre-requisites have been met.
Could not enforce prerequisite compliance.
Data Repository Prerequisite Compliance Status on host xxx -- FAIL!"

Resolution

Simply reboot the DR nodes and run the dr_validate script again.  If you get the same after running the validate, you should reboot the servers again and rerun the script