Ca7load step insertion.

Products

• CA 7 Workload Automation

Issue/Introduction

Why is ca7load getting inserted?

STMT NO. MESSAGE                                        

       2 IEFC612I PROCEDURE CA7LOAD WAS NOT FOUND        

       2 IEFC611I OVERRIDDEN STEP NOT FOUND IN PROCEDURE

Environment

Release : 12.1

Component :

Resolution

There are several things that cause a load to get inserted: 

1- someone set the RELOAD=Y on the job definition screen
2- someone edits the JCL for a job thru CA 7 and if RELOAD=N is set, it will change automatically to RELOAD=Y    (the most common reason)
3- someone issue the LOAD,JOB=jobname   command.... (not likely)

To prevent CA 7 from inserting the LOAD STEP, set RELOAD to =X