search cancel

Schedule execute twice

book

Article ID: 229118

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine

Issue/Introduction


Transaction are not make a check if the ask is already generating, running or finished during the processing of the MJSCH the EJPP where entries for the task are read. During the processing of MJSCH a check should be made if the current ejpp_status allows the task to run. If not, the task should not be started. Currently, It just updates the status and sends the AKTX, independent of the current status. The AWI on the other hand does not allow the start of already running/finished tasks with 'go immediately'. Consequently, schedule execute twice.

Reproduction Steps:
1. Start a schedule with a task slightly in the future.
2. open 2 AWI sessions, and Open Last monitor for the scheduler.
3. upon task selection, both show 'go immediately' available.
3.1 Start task in session1 - taks starts.
3.2 Start task in session2 - task also starts -> NOK!

 

Environment

Release : 12.2 to 12.3.6

Component : AUTOMATION ENGINE

Resolution

Solution:

Update to a fix version listed below or a newer version if available.


Fix version:

Component(s): Automation.Engine

 

Automation.Engine 12.3.8