How to add NTSLOG Dataset dynamically

Products

• NetMaster Network Automation
• NetMaster Network Management for TCP/IP

Issue/Introduction

I have installed NetMAster V12.2 and allocated NTSLOG dataset as below

SYS4.NM.NMC2.NMNET.XXXX.NTSLOG                                     

SYS4.NM.NMC2.NMNET.XXXX.NTSLOG.D                    26460    ?    84

SYS4.NM.NMC2.NMNET.XXXX.NTSLOG.I                         149    ?    47

Looks like I have to reallocate NTSLOG with more space. Is there ant way I can add new allocated dataset dynamically without any disruption. 

Environment

Release : 12.2

Component : CA NetMaster Network Automation

Resolution

You will need to stop SAW (session Awareness) before you can ACTION the parameter group.

Once you ACTION the group then you will need to START SAW.

 

Below is an example - issued from CMD - command entry

 

saw stop close=all                                                             
N75109 SAW TERMINATION IN PROGRESS.                                            
N75203 SESSION AWARENESS PROCESSING NOW INACTIVE.    

<action the parameter group>
                         
saw start                                                                      
N75002 START SAW PROCESSING REQUEST ACCEPTED BY VTAM. 
                         
sh udb=ntslog                                                                  
N13521 DDNAME   FILEID   TYPE A/U SM DATA EXT INDX EXT RKP KYL UKY STUS OPTNS  
N13522 NTSLOG   NTSLOG   BASE   1  8  52%   2  87%   2   0  64 -   AVAL SLN    
N13503 *END*                                                                   
** END OF DELIVERED MESSAGES **