ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

BGP Prefix reporting in DX Netops Performance Management

book

Article ID: 228044

calendar_today

Updated On:

Products

CA Performance Management - Usage and Administration DX NetOps

Issue/Introduction

We need to report on the following two OIDS:

1.3.6.1.4.1.9.9.187.1.2.1.1.1 cbgppeerprefixaccepted
1.3.6.1.4.1.9.9.187.1.2.1.1.6 cbgppeerprefixwithdrawn

 

Environment

Release : 3.7

Component :

Resolution

The OIDs:

1.3.6.1.4.1.9.9.187.1.2.1.1.1 cbgppeerprefixaccepted
1.3.6.1.4.1.9.9.187.1.2.1.1.6 cbgppeerprefixwithdrawn

Vendor Certification: Cisco BGP Peer Address
Metric Family: Router


You would need to add the Metric Family: Router to a Monitoring Profile and apply that monitoring profile to a Collection the device is in.

Then check the Polled Metric Families on the device from the DA Device Admin page for the device to verify if the "Cisco BGP Peer Address" is showing "Supported" under the Router metric family.

You can also see any components created by selecting the row that contains the Router Metric Family.

Also see:

https://knowledge.broadcom.com/external/article?articleId=194772