Vantage -Crash partition with VAN0590E: GETMAIN FAILED

Products

• Vantage Storage Resource Manager

Issue/Introduction

Execution of the Vantage DSNCTLG audit script fails with GETMAIN FAIL error when collecting data for volumes with a large VTOCs (VTOC
of size 100CYL) is being done. Data are not collected for the following objects located under Catalog Management - Audits - Catalog Entries Not
On Disk:
(DSNCTLGD) Details of Online Volumes
(DSNCTLGO) Details of Offline Volumes
  

and the following messages are present in JESMSGLG part of the Vantage STC log:
VAN0590E: GETMAIN FAILED, LEN=    131,222,148 SP=000 ID=VtocBufr GETMAIN
AREA   G CALLER=GENVTOCR OFFSET=00000D1E
VAN0590D   1,366,294,528=REGION LIMIT FOR MEMORY ABOVE THE LINE
VAN0590D      70,586,368=MAX LENGTH CURRENTLY AVAILABLE ABOVE THE LINE (AT ADR=35E08000)
VAN0590D       9,412,608=REGION LIMIT FOR MEMORY BELOW THE LINE
VAN0590D       5,414,912=MAX LENGTH CURRENTLY AVAILABLE BELOW THE LINE (AT ADR=00322000)
VAN0591E: READ OF VTOC ON VOL=S$SM00 FAILED. RC=4 (GETMAIN FOR BUFFERS FAILED)
 

 
CIRCUMVENTION:
Exclude the volumes with large VTOCs via INCLEXCL member through one of
following sections:
START-EXCLUDE-VOL
START-EXCLUDE-CUA

Environment

Release : 14.0

Component : CA Vantage Storage Resource Manager

Resolution

To correct this problem the LT03372 test apar should be applied

OR 

Exclude the volumes with large VTOCs via INCLEXCL member through one of following sections:

START-EXCLUDE-VOL

START -EXCLUDE_CUA

To obtain the LT03372 test apar , Broadcom's support should be contacted.