ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Issue creating some Infoblox devices configured in active, standby and virtual node in Spectrum when using "Model by IP"
Article ID: 227722
Updated On:
Products
CA Spectrum
DX NetOps
Issue/Introduction
Issue creating some Infoblox devices configured in active, standby and virtual node in Spectrum when using "Model by IP"
When modeling the virtual node, if the active node is already modeled, the active node model is deleted and the virtual node model is created.
Same if the active node is already modeled and then modeling the virtual node. The active node model is deleted and the virtual node model is created.
Environment
Release : Any
Component : Spectrum Discovery / Modeling
Resolution
Model the Infoblox devices using the "Create by Model Type" choosing the InfobloxDev Model Type.
Additional Information
Reference the "Add a Device Using Create Model by Model Type" section of the documentation for more information.
Feedback
Yes
No
Powered by
