Deploy robot_update package

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

If we deploy robot_update package on more than 100+ servers there is one pop-up comes up to check on update only do we need to click that option.

 

It we do not click that option what will happen? What is the difference if we deploy robot_package without clicking update only?

Does it make any difference?

Environment

Release : 20.3

Component : UIM - ROBOT

Resolution

You must have the OC Automatic Robot Installation ACL permission to deploy robots automatically. Account contact users cannot deploy robots automatically. Also, the automated_deployment_engine probe version 1.10 or later must be running in your environment.
 
Administrators can also use either the GUI or the command-line interface for the automated_deployment_engine probe to deploy robots automatically.
 
For a list of platforms that support automatic robot deployment, see the Compatibility Matrix.
To deploy robots automatically, you must be a regular UIM user, and you must have the OC Automatic Robot Installation permission set in the ACL. Also, the automated_deployment_engine probe version 1.10 or later must be running in your environment.
OC uses the automated_deployment_engine probe to perform an ssh file transfer to a target. Typical deployment is performed through the primary hub.
 
Follow these steps:-
 
== Navigate Inventory view in the left navigation of the OC.
== In the Inventory view, select systems to deploy robots to. You can select the check box in the column header to select all the systems in the list.
== Choose Robot Deployment from the Actions menu.
== Click Deploy. The deployment is in progress message appears.