ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

ppm-25 error when trying to get into large snmpcollector

book

Article ID: 227119

calendar_today

Updated On:

Products

CA Unified Infrastructure Management On-Premise (Nimsoft / UIM)

Issue/Introduction

Getting a ppm-25 error when trying to get into large snmpcollector. Was working fine and then suddenly stopped working.

Environment

Release : 20.3

Component : UIM - SNMPCOLLECTOR

Resolution

Deactivated the ppm probe on the snmpcollector hub, making sure that the port and pid go away, then activate ppm and try to get into the snmpcollector configuration.