DBUTLTY LOAD FORMAT=EXTRACT using extracted data from another Multi-User environment ( called the source MUF) fails with
IEC141I 013-20
ERROR DESCRIPTION: IEC141I
An OPEN macro instruction was issued for a sequential data set using
QSAM. BLKSIZE is not a multiple of LRECL, or LRECL is 0 with RECFM=FB
or RECFM=FBS, or BLKSIZE is not at least four bytes greater than LRECL
with RECFM=V.
END ERROR DESCRIPTION: IEC141I
Release : 15.1
Component : CA DATACOM/DB
Before the load of the data can be executed ,DBUTLTY gets the table length from the CXX and then checks if the blocksize from the input data set is a multiple of the table length as found in the CXX.
If not, the LOAD fails.
Check and correct the table structure in the target MUF where the LOAD is executed.