ESP528E new application generation can't be created

Products

• ESP Workload Automation

Issue/Introduction

After the event is triggered, new application generation can't be created.

Environment

Release : All

Component : ESP Workload automation 

Resolution

Reviewed ESP STC jesmsglg and found ESP528E error message. This message indicates that some error has occurred during the execution of an Event. If the event was triggered by a dataset, the dataset is displayed after 'TRDSN'. If the event failed when submitting a job, the application name and its generation number is displayed. This message is followed by another message describing the actual error.

Correct the error in ESP Proc and trigger event again.

Note: Simulation shows same errors. When the schedule is changed, we recommend a simulation be done to make sure no errors show up.

Additional Information

ESP528e Message