ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

LDR01E unknown version of Mainview/IMS data with BMC AMI Ops Monitor for IMS Online 5.5 data

book

Article ID: 226451

calendar_today

Updated On:

Products

MICS Resource Management

Issue/Introduction

Customer runs CA MICS Analyzer Option for IMS in CA MICS Resource Management 14.2 with BMC AMI Ops Monitor for IMS online 5.5 data and received the message below.  

Is there a toleration PTF available to eliminate the warning?

LDR01E: CA MICS Analyzer Option for IMS                             

LDR01E:   * WARNING * WARNING * WARNING * WARNING *                 

LDR01E:     An unknown version of Mainview/IMS data                 

LDR01E:     has been detected in the input stream.                  

LDR01E:     Mainview/IMS Version Detected---------------5.5.00      

LDR01E:     Please contact customer support for                     

LDR01E:     assistance regarding this message.                      

LDR01E:   * WARNING * WARNING * WARNING * WARNING *                 

LDR01E: CA MICS Analyzer Option for IMS                         

 

    

Cause

Toleration support is required to eliminate the WARNING in the IMS00304I message in the MICSLOG when processing BMC AMI Ops Monitor for IMS Online 5.5 (formerly Mainview for IMS) accounting data. 

Environment

Release : 14.3

Component : CA MICS IMS ANALYZER

Resolution

Apply PTF LU03123.
 

IMS6726 - Toleration Support for BMC AMI Ops Monitor for IMS Online 5.5

Solution Document: LU03123

 

Additional Information

See MIMS problem record # 14760 for BMC AMI Ops Monitor for IMS Online 5.5 toleration (previously known as BMC Mainview).

PTF LU03123 is now available for customer download.
  •  
Powered by Wolken Software