ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
SDC/TrapX range filters not working as expected
Article ID: 226159
Updated On:
Products
CA Spectrum
DX NetOps
Issue/Introduction
SDC/TrapX range filters like the following are not working as expected:
filter * * * 6 [1-5] 1.3.6.1.4.1.6889.2.17.1 forward 10.173.32.90:162
Cause
A defect in the regexp filtering
Environment
Release : 20.2.1/10.4.3
Component : Spectrum Trap Exploder
Resolution
This issue is currently in the backlog to address in a future release. No specific release specified when this knowledge article was published.
Until then, you will need to specify the specific id's separately.
Additional Information
Please review "SDC TrapX filters not working as expected" for an additional filter issue.
Feedback
Yes
No
Powered by
