Getting a Panvalet PV009 INVALID PARAMETER on a ++CONTROL card

Products

• Panvalet

Issue/Introduction

Receiving the following error trying to do a Transfer from PANLIB to another PANLIB:

iprfx.PROD.PANVALET                         
++CONTROL ***                                                                   
***** INVALID PARAMETER *****                        * ERROR MESSAGE  = PV009 *    

 

 

 

        

      

Environment

Release : 14.6

Component :  Panvalet

Resolution

When a PV009 Invalid Parameter error occurs on a ++CONTROL statement, it indicates that the Control Code is incorrect.

Verify that Control code specified is correct for the PANLIB involved.

If you believe that the Control code is correct, open a Panvalet support case on the Broadcom Support Portal