ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Steps to enable SNMP on DLP Web Virtual Appliance


Article ID: 225487


Updated On:


Data Loss Prevention Network Prevent for Web Virtual Appliance


You would like to enable SNMP on DLP Web Virtual Appliance, so that the SNMP application/manager is able to poll metrics like CPU, memory, disk from the DLP Web Virtual Appliance. 


By default, SNMP is disabled on DLP Virtual Appliance. 


You need to run the below commands to enable SNMP on the DLP Virtual Appliance. 

snmp agent enabled
snmp agent version v2c
snmp community public
snmp vacm view bc subtree 1.3 included
snmp vacm group public member public sec-model v2c
snmp vacm group public access v2c no-auth-no-priv notify-view bc read-view bc write-view bc