Is there a way to use OData to query for components that have a status of "Not Present"?

Products

• CA Performance Management - Usage and Administration
• DX NetOps

Issue/Introduction

There are many components in the Data Aggregator with a status of "Not Present".   These components were discovered in the past but no longer exist on the device.  Is there a way to retrieve these "Not Present" components via the OData UI?

 

 

Environment

Dx NetOps Performance Management any version

Resolution

Odata will only show active interfaces not 'filtered' or 'not present'.   Also, for example, if change detection hasn't run to convert Active to Filtered, it will still appear in reports until change detection runs.  And once it does, we run our ETL process 1/hour (usually 15mins past the hour) to rebuild the table of active items used for ODATA queries.