When running Pre-Conversion job (AL2DCB10), step JS010 is required to issue the following command in the SYSIN area:
The job completes with a rc=8, with the following error:
SAN0-25 SECURITY UID MUST BE 255 FOR THIS COMMAND
However my UID is set to CA70255 and I do have read access granted to panel CA70255
Can you advise what may be causing this to happen?
This error is caused by not having the SASSRTBL Resource module coded and implemented.
Release : 12.0
Release : 12.1
Component : CA 7
Note: There is no need to implement this module to satisfy the JS010 step. You can comment out the JS010 step and proceed with JS020.
Expect a rc=0.