WLM$011W INTERVAL DATA IS NOT AVAILABLE. TOTAL USED

Products

• SYSVIEW Performance Management

Issue/Introduction

When I issue the WLM command, and then select the Workload row (The command issue is WMSYSSUM), I get the message 

WLM$011W INTERVAL DATA IS NOT AVAILABLE. TOTAL USED

How can I prevent this message from being issued?

 

Environment

Release : 16.0

Component : SYSVIEW

Cause

WLM-INTERVALS parm is still set to the default of 15

Resolution

Check the MVSDATA Parmlib member. If the WLM-INTERVALS parm is still set to the default of 15, increase the value to 60, put it above the )EOF marker and then recycle the MVSDATA portion of SYSVIEW.

Option  : WLM-INTERVALS 
Default : 15

Specify the maximum WLM collection intervals.

Valid values: 
   Minimum   - 5
   Maximum   - 60

For more information see example of WLM-INTERVALS in the MVSDATA section of the CNM4BPRM area of the manual.

Additional Information

Warning message WLM$011W

MVS Data Collection Subtask Setup