Getting an error while Adding workspace to OPL with Post,man API call

Products

• BlazeMeter

Issue/Introduction

Getting "Could not get any response" error in Postman while adding a workspace to a Private Location using the https://a.blazemeter.com/api/v4/private-locations/<harborId>/add-workspace API:

 

SSL certification is off in Postman.

Cause

If there are no active BlazeMeter incidents reported at the time of the error, then the issue is most likely a misconfigured proxy server in Postman or a network and/or proxy issue.

Environment

Release : SAAS

Component : BLAZEMETER GENERAL PLATFORM ISSUE

Resolution

If there is a proxy between the system where Postman is being used to make the API call and a.blazemeter.com , then check the Postman Settings->Proxy configuration to make sure that the proxy is properly configured.

May need to engage the network and/or proxy administrators to determine what is blocking access to a.blazemeter.com from the system where Postman is issuing the API call if the proxy is correctly configured in Postman.