PSP refresh job ESDxxxxL gets U0100 abend in PSPEXEC

Products

• MICS Resource Management

Issue/Introduction

The PSP refresh job, ESDxxxxL, abends with a U0100 in the PSPEXEC step when running with MODE=RPT.  Is this normal?

Environment

Release : 14.3

Component : CA MICS BASE SET

Resolution

Yes, if the job was submitted with MODE=RPT, then the PSPEXEC step must abort with an ABEND code of U0100.
If the job was submitted with MODE=DASD, PSPEXEC and all subsequent steps must complete with a condition code of zero.
In addition, the step #PCHFND might complete with a condition code of 2 as part of normal operation.

Additional Information

Refer to the PSP refresh Checklist for more information.