Loading JMeter jtl file using Taurus to show more than 100 element labels does not show all labels

book

Article ID: 220532

calendar_today

Updated On:

Products

BlazeMeter

Issue/Introduction

Not able to load the full number of labels after following instructions in the Using Taurus for Load Tests with 100+ Labels blog

Cause

The information in this blog do not work since they incorrectly attempt to by-pass BlazeMeter element label limitations specified in the Aggregated Labels section of the Request Stats Report article.

Environment

Release : SAAS

Component : BLAZEMETER PERFORMANCE TESTING

Resolution

Only 100 element labels for a single test and 300 element labels for a multi-test can be displayed (current BlazeMeter limitation) for tests executed from BlazeMeter.

The instructions in the blog to by-pass these limitations are not correct and should not be used.

The correct solution is to redesign the script(s) used in the Performance test(s) to limit the number of element labels the test will generate to keep the number under the current limits, then run the script from BlazeMeter.