"-" shown under details of Business Application in DUX

Products

• CA Automic Dollar Universe

Issue/Introduction

Sometimes "-" shown on the UI of the DUX business Application. What does "-" mean?

Environment

• Release : 6.10.x
• Component : DOLLAR UNIVERSE
• Sub-Component: Dollar Universe Explorer (DUX)

Cause

The "-" shown on DUX UI is also a bar whose dimension can't be plotted and is an expected behavior from product.

Resolution

To plot the bar system calculate the execution duration and based on which it plots the bar dimensions. Note that execution duration shown on DUX UI spans for 24 Hours and hence mini-scale runs bars with hard to plot dimensions can't be plotted on hour columns, hence "-" is shown .

In the cases where the execution is very small i.e. run completed in seconds or less, the system cannot plot these mini-scale dimension for bar and hence shows "-". if you mouse over to this it will show respective status same as that for bar.

Keystone Job status where system is able to plot the bars: