How to determine CA SymDump Batch registered to health checker?
Article ID: 219560
Updated On:
Products
Issue/Introduction
Unable to determine if CA SymDump Batch was registered to use health checker.
How to verify the CA SymDump Batch health check registration? HZSPROC messages and could not access the CAHCHECK messages at all.
Environment
Release : 11.0
Component : CA SymDump Batch
Resolution
The SYMDUMP_BATCH_REPOSITORY_STATUS should automatically be registered in Health Checker during the initialization process.
If SYMDUMP_BATCH_REPOSITORY_STATUS is registered in Health Checker and the repository is full,
The CAPHC001W message generated in SYSLOG and also in IBM/CA Health Checker.
To check this it in :
CA SYSVIEW -> command 'MENU HCHECK' -> '2 HCHECKER' or SDSF -> HCHECKER
Additional Information
CA SymDump Batch repository file is nearing capacity.
File prtlib.name is at nn.n% capacity.
If the repository becomes full, future abend reports will not be captured.
Reason:
The index file has met or exceeded the capacity trigger set in the CAOETABL options table parameter PRTLHCT=. The CA SymDump Batch PRTLIB file is filling up and may not have the capacity to save future abend reports.
Action:
The CA SymDump Batch repository file must be maintained using utility program CAOUPRTU. Procedure CAIPRTU can be used to execute the utility to copy or delete dump reports from the repository file to free space for future abend reports.
Feedback
