Determining appropriate time to start CA-11
Article ID: 218389
Updated On:
Products
CA-11
Issue/Introduction
What Datacom DB message can we use for OPS automation to determine when Broadcom's Datacom has fully initialized so we can immediately start products
that depend on its full initialization?
Environment
Release : 11.0
Component : CA-11
Cause
When Datacom has fully initialized, it generates the following message: DB00201I
Resolution
You should key off:
MUFJOBT7:DB00201I - MULTI-USER ENABLED, CXX=CXXR14 MUFNAME=CXXR14A
The DB00201I means the MUF is fully enabled.
Feedback
Yes
No
Powered by
