Need to install the Admin Console on a remote hub for troubleshooting

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)
• Unified Infrastructure Management for Mainframe
• CA Unified Infrastructure Management SaaS (Nimsoft / UIM)

Issue/Introduction

Need to install Admin console on a remote hub to try and access a specific robot (controller) which is throwing a configuration error.

Environment

Release : 20.3

Component : UIM - ADMIN_CONSOLE

- UIM 20.3x

Cause

- troubleshooting purposes

Resolution

Deployed the following probes to the remote hub:

1. wasp
2. uimhome
3. adminconsoleapp
4. mps
5. mpse

PPM, baseline_engine and prediction_engine will automatically install with adminconsoleapp. Please make sure they are started.

Set the wasp data_engine key under the setup section to the full data_engine address from the Primary hub.

Setup the cryptkey (certificate.pem)