EEM 12.6.2- 2048 certificate and configuring multi-write order

Products

• Autosys Workload Automation

Issue/Introduction

I have installed EEM 12.6.2 on a windows 2019 server - primary and secondary .

When should I generate the 2048 certificate that is needed for WCC?

Should I do this before configuring the EEM failover/setting up sync between secondary and primary EEM?

OR after I install EEM, do I generated 2048 certificate and then configure the primary and secondary EEM for synchronization?

 

Environment

Release : 12.0

Component : CA Workload Automation AE (AutoSys)

Resolution

Install the first EEM.
Perform any key adjustments if needed.
Install the second EEM.
Perform any key adjustments if needed.
Then configure them into multi-write with one another.