Is it possible to monitor a robot from two hubs?

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)
• Unified Infrastructure Management for Mainframe
• CA Unified Infrastructure Management SaaS (Nimsoft / UIM)

Issue/Introduction

Is it possible to have a robot active/monitored from two hubs at the same time using a different IP address for each robot? I've been exploring the possibility using passive robots but cannot get both robots to stay active at the same time.

Environment

Release : 20.3

Component : UIM - ROBOT

Resolution

This is unsupported/untested.

There are no options currently available in the robot.cfg that would allow this, using the same hostname, only HA/robot failover, like an active/passive or primary/secondary approach.

The robots would have to have different hostnames/FQDNs not just different IPs.