Error adding discovery scope on UIM 20.3.2

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Currently on UIM 20.3.2 and having issue on trying to create Discovery Scope ,

Getting Error Adding Scope. According to Release notes for 20.3.3 this is fixed in 20.3.3.

Need a workaround solution on UIM 20.3.2  

 

 

Environment

Release : 20.3.2

Component : UIM Operator Console - Inventory

Cause

Defect

Resolution

Engineering  has provided "operatorconsole-api.jar" 

Note :this patch is specific to uim 20.3.2 and running ump_operatorconsole :2.08hf3

 

Below are the steps to deploy the jar file:

 1. Deactivate the wasp probe where OC is running

 2. Take backup of the work folder.

 3. Take the backup of the "operatorconsole-api-2.0.8.jar" from the location "Nim_Install_dir/probes/service/wasp/webapps/operatorconsole_portlet/WEB-INF/lib" to some other location 

4. Delete the "operatorconsole-api-2.0.8.jar" from above location "Nim_Install_dir/probes/service/wasp/webapps/operatorconsole_portlet/WEB-INF/lib"

5. Download the  "operatorconsole-api.jar"  from the case and copy to the folder  "Nim_Install_dir/probes/service/wasp/webapps/operatorconsole_portlet/WEB-INF/lib"  

5.  Activate the wasp probe and verify the issue .

 

In case issue is not fixed and rollback is required below are the steps

Steps To Rollback:

1. Deactivate the wasp 

1. Delete the  "operatorconsole-api.jar" from the folder  "Nim_Install_dir/probes/service/wasp/webapps/operatorconsole_portlet/WEB-INF/lib" 

2. Copy the  "operatorconsole-api-2.0.8.jar" from the backup (Step 3 from above step) and paste into the folder "Nim_Install_dir/probes/service/wasp/webapps/operatorconsole_portlet/WEB-INF/lib"

3. Restart the wasp ( If still getting issue delete the work folder and restart the wasp)