How to install FarPoint TabPro OCX for use with Gen 8.6?
Currently, it is the only supported Tab control with Gen: Gen 8.6 > Technical Requirements > General Comments > Active Control Support Policy
Release : 8.6
Component : Gen Workstation Toolset
To place a FarPoint TabPro OCX on a GUI C Window, a complete licensed package needs to be installed.
The FarPoint TabPro Product Code and Serial Number are required for installation and can be acquired from [email protected] if needed.
The installation package can be downloaded using the following link: http://download.componentone.com/pub/Trials//TabPro/tptrial.zip
After downloading the zip file, run the enclosed setup.exe.
For additional questions about the FarPoint TabPro OCX, contact [email protected].