Can message PTABDBS Error performing ACM initialization be ignored executing Recovery Analyzer
Article ID: 21621
Updated On:
Products
Recovery Analyzer for DB2 for z/OS
Issue/Introduction
Installing Recovery Analyzer for Db2 for z/OS (PRA) and executing the Post Installation Task:
Setup PRA#LOAD Batch JCL
The generated PRA#LOAD job completes successfully with a return code 0, however the following message has been issued in the job output:
PTABDBS: Error performing ACM initialization
Is this an error or can this be ignored?
Resolution
This message is generated when ACM, Alternate Catalog Mapping, has not been setup prior to running the PRA#LOAD Post Install task.
It can also be seen if an ACM is not in use and the actual PRA#LOAD job is being executed.
The message is acceptable in these circumstances and can be ignored.
Additional Information
Feedback
Yes
No
Powered by
