Flyout fields stick if Edit not exited correctly

Products

• Clarity PPM On Premise
• Clarity PPM SaaS

Issue/Introduction

After we edit the Flyout, if we haven't exited it properly, the flyout starts behaving weirdly and any changes do not stick

 

STEPS TO REPRODUCE:

1. Connect to Clarity 15.9.3
2. Go to Project List in MUX (happens on other object flyouts)
3. Now Create two new views as duplicate to Standard
4. Open a Flyout - click Configure - Resize the Name field and put it on top
5. Switch Start and Finish fields
6. Stay in Configure mode do not Exit
7. Switch the View to another Saved view
8. Discard changes
9. Now note the fields switch back but we are still in Edit Mode, we see "Exit"
10. Attempt the same changes again, resize Name on top and Switch Start and Finish fields
11. Note changes are reverted and Note the Configure/Exit link is missing
12. Try to do any changes to the View

 

Expected Results: To be able to make changes

Actual Results: As soon as you switch Start and Finish, Note The Configure/Exit link disappears. The fields stick and all changes done are reverted back

 

Environment

Release : 15.9.2

Component : CA PPM PROJECT MANAGEMENT

Resolution

Workaround: Make sure you Exit correctly after any changes and reopen the flyout again.

This is DE61068, fixed in 15.9.3