search cancel

20.3.3 Custom Data/Time selection in Metric Viewer not working

book

Article ID: 214810

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Version 20.3.3

Problem:

the custom date/time selector at times not showing any charts/data depending on the date/time start chosen.  A closer look it gets worse, the chosen start and end times are not the reflected start and end times when the charts [are] rendered. 

Environment

Release : 20.3

Component : UIM OPERATOR CONSOLE - METRIC VIEWER

Resolution

This is a known defect that has been fixed in the June patch release of UIM 20.3.3