MIM0123E Unrecognized command VARY
book
Article ID: 214727
calendar_today
Updated On: 05-10-2021
Products
MIM Tape Sharing (MIA)
Issue/Introduction
Receiving the following messages when trying to vary a range of devices NOTAVAIL on one of our systems:
@VARY (2860-287B) NOTAVAIL
MIM0067I Command VARY 346
MIM0123E Unrecognized command VARY
Environment
Release : 12.5
Component : MIA
Cause
The VARY command is only valid where MIA GTAF and TPCF are active.
Resolution
- If MIA GTAF and TCPF are active, use command against appropriate address space by either using correct command character or use MODIFY command
- Issue command "@D FACILITIES" to determine what facilities that are active on the local system and what service level you are running on each facility
- Issue command "F MIM,D FAC" and all MIM address spaces would have responded, if there was more than one.
Feedback
Was this article helpful?
thumb_up
Yes
thumb_down
No