TDYNIBM/EJECT fails but with RC=0
Article ID: 213872
Updated On:
Products
Dynam for VSE
Issue/Introduction
Due to a hardware problem in the tape system, Dynam/T tape eject step occasionally fails.
The problem is that the job ends with RC=0 so the hw problem remains unnoticed by the batch workload management team.
What is required for TDYNIBM to do when this happens is to return RC>0.
Is there a way to control the RC returned by the program TDYNIBM?
Resolution
PTF LT01049 resolves this issue
Feedback
Yes
No
Powered by
