ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
SSH uses source ip of the primary SS when failed over to the secondary SS
Article ID: 213790
Updated On:
Products
CA Spectrum
Issue/Introduction
If the primary SpectroSERVER (SS) process fails and OneClick (OC) fails over to the secondary SS, when a user runs an SSH from a model in the OC console, the source ip used for the SSH session is the source ip of the primary SS and not the secondary SS.
Cause
The Spectrum telnetd process is a relay host for all the OC telnet and SSH sessions. If the telnetd is still running on the primary SS system when the primary SS application is down, OC will use the telnetd running on the primary SS system.
If the telnetd is not running on the primary SS system, OC will use the telnetd running on the secondary SS system.
Environment
Release : Any
Component : Spectrum OneClick
Resolution
This is functioning as designed.
Feedback
Yes
No
Powered by
