How do enable the option within the AAI Edit Jobstream page to "Trim job with No Run Frequency"
search cancel

How do enable the option within the AAI Edit Jobstream page to "Trim job with No Run Frequency"

book

Article ID: 213127

calendar_today

Updated On:

Products

Automic Automation Intelligence

Issue/Introduction

Hi Team,

 

Below conditions/options are missing in jaws UAT while editing or making config changes for the job stream. So, currently onboarding team unable to migrate anything to UAT. 

1) Start Job

2) Trim job with No Run Frequency

Attached the screenshot of UAT (Not avail) and Prod (its avail) just for comparison.

Please note that both Prod and UAT are in same version (6.0.2-2) , and those conditions are visible in Prod but not in UAT.

 

Thanks,

Mani

Environment

Release : 6.0.2

Component : AUTOMIC AUTOMATION INTELLIGENCE INTEGRATION FOR BMC

Resolution

1. Open the configuration tool from <install dir>/config/ran.sh(bat)

 

2. Go to the Params tab.

 

3. Under "less commonly configured" find "showAutoTrimJobsWithNoRunFrequencyOption" and set to True.

 

 

4. Once these are set to True, you will need to close out of your AAI/JAWS client and relaunch it to see the changes on the Edit Jobstream page.