What causes message 'N11420 SYSTEM OPERATING WITH type SECURITY EXIT' not to be part of the STATUS command output?

Products

• CMDB for z/OS
• NetSpy Network Performance
• NetMaster Network Automation
• SOLVE
• NetMaster Network Management for SNA
• NetMaster Network Management for TCP/IP
• NetMaster File Transfer Management
• SOLVE:Operations Automation
• SOLVE:Access Session Management
• SOLVE:FTS

Issue/Introduction

Introduction:

We provide one case when message N11420 is not part of the STATUS command output.

Question:

Why the STATUS command output may not contain message 'N11420 SYSTEM OPERATING WITH type SECURITY EXIT'?

Answer:

If the SOLVE or NetMaster region was started up using parm SEC=NO on the RUNSYSIN startup member, external security

is not applicable.  In this case, message N11420 will not be part of the STATUS command output.

Environment

Release: SLACCS00200-5-SOLVE:Access-Session Management

Resolution

See Answer above.

Additional Information

The location of N11420 on the SOLVE--NetMaster tech docs follows:

 

https://techdocs.broadcom.com/us/en/ca-mainframe-software/performance-and-storage/ca-netmaster-messages/1-0/n0x-to-n1x-messages/n11420-system-operating-with-type-security-exit.html