ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

CABI custom report with snmpcollector data cannot be created: missing CI Name

book

Article ID: 212743

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

I'm tyring to create a simple report for one source, with QOS from bits in/ bits out QOS from snmpcollector and showing raw data.  (interfaces and showing bits in and bits out)
 
 
 
 

However, when we save it as a report and try to run it, it shows the following and we cannot proceed:

 


The issue is that it needs “CI NAME”

What is supposed to go there in CI Name?

This is blank and without this field, the report won’t save.

 

Cause

Wrong filter configured

Environment

Release : 20.3

Component : UIM - CABI

Resolution

Change your filter to "contains", and save the report.

You will then be able to change the filter to whatever you want when you run the report. 

 

 

Attachments