ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Spectrum NCM: How to run an SSH Capture for Cisco CatOS devices
Article ID: 212108
Updated On:
Products
CA Spectrum
Issue/Introduction
Cisco CatOS device was correctly populated to the expected device family but there is only one capture method.
How can we use SSH for the capture method for Cisco CatOS devices?
Environment
Release : 10.4.x
Component : Spectrum Core / SpectroSERVER
Resolution
- CatOS device family only has the one capture type.
- Move the device(s) to a non-default device family if you want to use SSH for the captures.
Feedback
Yes
No
Powered by
