PSI/DBCS messages in new function mode

book

Article ID: 211732

calendar_today

Updated On:

Products

CA Easytrieve Report Generator

Issue/Introduction

I have installed 11.6 (20858711) plus latest nmaintenance (SP4 and some since). 

When we run in compatibility mode, we (so far) see like-for-like. 

When we run in new function mode, we get this with a return-code 00 (in spite of it being a "severe error"). 

The messages don't have message-id.'s and I can't find them in Google.   They appear to refer to (the 11.6) CODE parm setting (there is no equivalent in the Options Table), so I ran it again with PARM CODE PROCESS (EBCDIC) - but, this produces the same outcome. 

+++PSI/DBCS SUBSYSTEM ERROR+++                    
+++LOCATION:                                      
PSIDBSYS.GETDBC                                   
+++REASON:                                        
PSI/DBCS SUBSYSTEM HAS NOT BEEN ACTIVATED.        
+++PSIDB RC OF 134.                               
ERROR IS SEVERE. PROGRAM TERMINATED.              

What do these messages mean - and where do I look to see how to fix them. 

 

Environment

Release : 11.6

Component : CA Easytrieve Plus Report Generator

Resolution

Test apar LT00195 

SUMCTL TAG FAILS IF SO05162 IS INSTALLED WITH DBCS DISABLED
Apar No - LT00195

 
PROBLEM DESCRIPTION:
The program compilation fails if SUMCTL TAG statement is used and
SO05162 was installed with DBCS subsystem disabled.
 
SYMPTOMS:
The program compilation fails with the following error:
   +++PSI/DBCS SUBSYSTEM ERROR+++
   +++LOCATION:
   PSIDBSYS.GETDBC
   +++REASON:
   PSI/DBCS SUBSYSTEM HAS NOT BEEN ACTIVATED.
   +++PSIDB RC OF 134.
   ERROR IS SEVERE. PROGRAM TERMINATED.