Interface still appears in sub-group of the group of the group the rule is based on in DX Netops Performance Management

book

Article ID: 211194

calendar_today

Updated On:

Products

CA Performance Management - Usage and Administration DX NetOps

Issue/Introduction

Interface still appears in sub-group of the group of the group the rule is based on in DX Netops Performance Management

For example:

Top Group     --> Group of Interfaces created via rule
\_Sub Group A --> Has a rule based on the contents of Top Group
\_Sub Group B --> Has a rule based on the contents of Top Group

The interface was removed from Top Group, but I can still see in Sub Group A 

Environment

Dx NetOps Performance Management 20.2

Resolution

Do not base rules for sub-groups on a group higher in the stack as the check on the higher group traverses the sub-groups when run.