Teleview is significant cause of IRA200E AUXILIARY STORAGE SHORTAGE

Products

• Teleview
• TELEVIEW- PACKAGE
• TPX - Session Management
• Vman Session Management for z/OS

Issue/Introduction

Description:

Starting Teleview on new LPAR and the following messages show up in SYSLOG a few minutes after starting Teleview:

00000281  $HASP309 INIT 21   INACTIVE ******** C=WABMLCSD1EU
00000090 *IRA200E AUXILIARY STORAGE SHORTAGE
00000090 *IRA206I TELEVIEW ASID 003D FRAMES 0000005266 SLOTS 0000311909 % OF AUX          82.5
00000090 *IRA206I DSSISTC  ASID 0046 FRAMES 0000000078 SLOTS 0000007261 % OF AUX           1.9
00000090 *IRA206I JES2     ASID 001C FRAMES 0000001266 SLOTS 0000007127 % OF AUX           1.8
00000090 *IRA206I TCPIP    ASID 004E FRAMES 0000000530 SLOTS 0000006763 % OF AUX           1.7
00000090 *IRA206I OMVS     ASID 000E FRAMES 0000003044 SLOTS 0000005614 % OF AUX           1.4
00000090 *IRA210E EKM      ASID 005C SET NON DISPATCHABLE  FRAMES+SLOTS 00000024           RATE 002237
00000281  IST530I AM GBIND PENDING FROM CDRM02 TO CDRM03 FOR CDRM03 752

Solution:

Rebuild the VBLDOPTN file.

The VBLDOPTN file should be reallocated anytime there are any changes in the operating system or if Teleview gets moved to a different LPAR.

• The VBLDOPTN file is built by the G644ALC member in SAMPJCL, at installation , and starts out empty.
  
  
• Teleview writes the high water mark of storage used while the region is up. When Teleview is restarted, it reads the file and GETMAINs 80% of the last high water mark at startup.

It is important that each of the Teleview regions have a new file. If you use the old one, the region will getmain too much storage.

If this does not resolve your problem with auxiliary storage, please contact CA Support with the following information:

• SYSLOG including the IRA200E message
  
  
• Teleview VLOGSYS for the corresponding time period
  
  
• Details on any recent system or Teleview changes

Environment

Release:
Component: TLVIEW