pu commands parameter details for usage metering probe

book

Article ID: 210977

calendar_today

Updated On:

Products

DX Infrastructure Management

Issue/Introduction

Customer wants to use probe utility command parameter details for usage_metering probe.

Environment

Release : 20.1

Component : UIM - USAGE_METERING/BILLING

Resolution

Using the steps provided in this Techdocs

   - you can get a list of Commands Available for a specific Probe:

     C:\Program Files (x86)\Nimsoft\bin>pu.exe -u <username> -p <password> /domain/hub/robot/probe
 
 
The Commands Available from command-line interface if for the development use, support cannot support those configuration. And, right now, all the parameter details for each commands are not available for each probe because of the large list of parameters of all the UIM probes. 

Additional Information

According to the usage_metering probe document
 
   - you can get monthly (or with a different pre-defined frequency) reports without any command line configuration.
 
For additional automation option, use this link.