MODID ERROR FOR MOD ENTRY RTXACTSR IN SYSMOD RO97937 or LU00960 missing PRE ZRO6009

Products

• Roscoe

Issue/Introduction

We are in the process of installing z/OS 2.4.  I just RECEIVED all of the maintenance for ROSCOE by the Internet Service Delivery.  When I try to APPLY the maintenance, I keep getting a MODID error.

How do I get past this ?

GIM41802I    JCLIN PROCESSING WAS SUCCESSFUL FOR SYSMOD RO91908.               
GIM38201E ** THERE IS A MODID ERROR FOR MOD ENTRY RTXACTSR IN SYSMOD RO97937.  
GIM31901I    SYSMOD RO97937 DOES NOT SPECIFY ZRO6009 ON THE PRE OR SUP OPERAND.
             THAT IS CURRENTLY INSTALLED.                                      
GIM38201E ** THERE IS A MODID ERROR FOR MOD ENTRY RTXCLOSE IN SYSMOD RO97937.  
GIM31901I    SYSMOD RO97937 DOES NOT SPECIFY ZRO6009 ON THE PRE OR SUP OPERAND.
             THAT IS CURRENTLY INSTALLED.                                      
GIM38201E ** THERE IS A MODID ERROR FOR MOD ENTRY RTXSCRN IN SYSMOD RO97937.   
GIM31901I    SYSMOD RO97937 DOES NOT SPECIFY ZRO6009 ON THE PRE OR SUP OPERAND.
             IS CURRENTLY INSTALLED.                                           
GIM22601I    APPLY PROCESSING FAILED FOR SYSMOD RO97937. 
                                                                               
GIM38201E ** THERE IS A MODID ERROR FOR MOD ENTRY DSNAPFMT IN SYSMOD SO07467.  
GIM31901I    SYSMOD SO07467 DOES NOT SPECIFY QO86150 ON THE PRE OR SUP OPERAND.
             THAT IS CURRENTLY INSTALLED.                                      
GIM22601I    APPLY PROCESSING FAILED FOR SYSMOD SO07467. 

 

Environment

Release : 6.0

Component : CA Roscoe Interactive Environment

Resolution

Accept ZRO6009. This is the service pack level FMID.

Apply RO88477 and then apply SO05092 in this order. All the remaining apars will go on fine after these two apars are applied separately. 

This will resolve the modid error

Another possible issue is the APPLY of LU00960. You may receive a PRE for ZRO6009 is missing. This would be caused by missing apar QO94897. You should be sure to apply QO94897, then apply SO11497. After these are applied then LU00960 will apply properly.