How to disable self monitoring alarms in the purestorage probe - (enable_self_monitoring_alarm not implemented)

book

Article ID: 210714

calendar_today

Updated On:

Products

DX Infrastructure Management NIMSOFT PROBES

Issue/Introduction

Some probes have the option to disable Self-monitoring alarms. This is achieved by adding this key to the setup section of the configuration file:

           enable_self_monitoring_alarm = false

Raw configuration --- > Setup ----> add enable_self_monitoring_alarm = false 

However, there are some old probes, for example PureStorage, for which this setting was not implemented. 

Is there any other procedure to do?

 

 

Cause

enable_self_monitoring_alarm key is not implemented in purestorage probe.

Environment

Release : Any

Component : UIM - PURESTORAGE

Resolution

 As an alternative, the recommended approach is the creation of a NAS rule to ignore these messages.

For example,

Filter out alarms

https://knowledge.broadcom.com/external/article?articleId=133773

 

Additional Information

purestorage (PureStorage All-Flash Array Monitoring)

https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/ca-unified-infrastructure-management-probes/GA/alphabetical-probe-articles/purestorage-purestorage-all-flash-array-monitoring.html