How can I configure the cdm probe to show the top processes that are consuming the most CPU via MCS enhanced profile/templates?
This option is available when configuring cdm via IM, but I didn't see it using MCS.
Release : 20.3
Component : UIM - MON_CONFIG_SERVICE_TEMPLATES
MCS Enhanced profile does not support "to show the N top processes that are consuming the most CPU" as Alarm Policy does not have capability to provide any such kind of information.
This is expected and known behavior and same has been published in CDM documentation. Please see below:
Few fields are not supported in the Setup CDM Enhanced template
Below are the few fields that are not supported in the Setup CDM Enhanced template, but are supported in the legacy template. Enabling these can have impact on the Monitoring data.
If you enable this field, there is no impact on the Monitoring data.
If you enable this field, you cannot see some QoS messages for the CPU monitoring.
If you enable this field,there is no impact on the Monitoring data.
If you enable this field, you cannot see some QoS messages for the Memory monitoring.